asist with remote start

[amsanders843]

Good evening, I just finished installing my remote start/alarm system in my 2004 grand prix. I used the bmw nitro 433 system with the 556U bypass module. EVERYTHING works fine except for remote starting the car. The alarm, door locks, trunk pop, etc all work accordingly. When I try to RS the car, I hear the bypass module clicking, nothing happens, and the whole system stops working. Then I have to unhook my neg batt cable n rehook it to get it workin again. I have the starter kill (normally closed relay) wired that 85 GWR, 86+30 starter key side, 87a starter side. Could this be the cause? Ive tested all of my wires, all carry the charge they're suppose to, to and from the system. Id really appreciate it if someone would help. I know the rs system isn't a usually used one such as viper, but that shouldn't b an issue. I can provide pics, etc to assist!!

[Norm]

Do you have a programmed key in the 556u? Does that key work to start the car?

[Norm]

http://assets.sonicelectronix.com/ma...cted/556uw.pdf

[amsanders843]

Yes I do, the key cranks the car just fine. Even if I leave the key in the ignition the remote start still wont crank the car. Shouldn't that at least work? Im so confused but I refuse to give up

[Norm]

Looks like relay is wired wrong then.

[amsanders843]

N I figured that might b the problem. So it HAS to b wired gwr to 85, Ign12V to 86, starter keyside to 87a, starter side to 30?

[The Buzz]

For the starter kill a pretty standard way to wire it is to run the -ground when armed to 85, the ignition + to 86, and each side of the starter to 87a and 30.
For the 556 you will just need +12v, ground, and -status output.