classic impreza install

[d4vew557]

the start of a homemade slide actuator to operate the boot floor

[d4vew557]

It's been a while since i posted any updates. Not that much to post really but here are a few pictures.

Ive been playing about with the amp rack. sorry about the poor quality of the pictures.





the bits of mdf on the front and sides are not part of it just what i was using to keep the top in the right place while marking the hole to be cut out.

[d4vew557]

here it is wit the the top on on the L.E.D's fitted




I'm disappointed with the way the light is shinning on the amps, its a bit random and not very uniform. I'm hoping when the perspex is fitted it will carry the light and look better.

[d4vew557]

well my sub should arrive on monday its been ordered for weeks.fingers crossed.

i got the perspex fitted in the cover for the amps, still not happy with the way the light is shinnig on the amps but i can play around with this later when its all fitted in the car.

im going to make my self a circle cutting jig for my router today but back at work tommorrow so not sure when i will get the sub fitted.

Once the sub is in i will be refitting everything so i will get some pictures then. ive ordered some carpet not enough to do the whole boot just a sample to see if i like it

[d4vew557]

got the hole cut in the sub box using my home made circle jig

[d4vew557]

i've recessed it 12mm in to the front so it still sits proud when the carpet is on it will stick out only a couple of mm

[d4vew557]

started to do so trimming today.

got the box covered and the amp cover




i found this to be harder than i thought it would, but it looks ok. a few dodgy edges on the amp cover but for a first attempt i think its ok.

[d4vew557]

well finally got the amps and sub in the car. Amp is powered up and sub is pumping away.

this is how it looks, not finished yet obviously but its getting there